![]() ![]() ![]() So I looked up remote adaptation and gave that a try (set value 1, press test and then save and then hold unlock button for at least 1 second until something blinks), but it never blinks anything to confirm the key is accepted. Unable to find any current fault codes I started working through the measurement blocks on the convenience unit and on page 10 found the blocks for the remote. I had a locksmith check the key is transmitting and he says it is transmitting strongly. There was an old code about key 2 having an intermittant fault (I only got 1 key with the car). ![]() Last week I got VCDS to sort out an airbag issue (ended up being a broken wire in the door boot), so have had a look for codes relating to the key/remote. I changed the battery again, the old one still has well over 3v though. On Sunday it stopped working completely, won't re-sync or anything.Ĭentral locking still works fine with the key in the lock, and if I don't turn the ignition on within 15 seconds the alarm goes off as it should (sometimes immediately, but usually 15 secs), and the car starts so obviously central locking, alarm and immobiliser are all stlll working, just the remote isn't doing anything. I have done the re-sync procedure a couple times when it didn't seem to work and it restored for a while. I changed the battery but it made no difference. I've had the car since October and the remote fob has always been a bit intermittant often needing a few presses for the car to respond. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |